![]() ![]() Try to make sure it is within 20 feet of your router. Your grill is too far away from your router.Make sure to correctly input the network and password. The network and/or password is incorrect.If steps 1-4 have been confirmed you may have a faulty igniter that needs to be replaced.ALWAYS make sure the hole is on the left near the thermal sensor and the half moon cut-out is on the right going into the grease trough. Reference the proper heat shield installation section under Assembly/Setup. Once the internal parts are removed and firebox is cleaned out, turn the grill on and wait to verify that pellets are being properly fed through the auger tube and into the firebox. The auger is not feeding clean dry pellets into firebox during cycle 0.Remove the internal components and clean out the firebox completely. ![]() Firebox is overloaded with pellets or ash.If you see the FAL code displayed shortly after turning the grill on you are experiencing an Ignition Failure which can be due to one of the following situations: Ignition Failure or Firmware Update Failure: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |